Computer Storage By Installing A Larger Hard Drive

Your Hard Drive is one of those components inside your computer that is mostly likely to

fail as the system gets older. This is because it is a mechanical device that uses motors, and

other moving parts that are guaranteed to wear out.

Before you remove the system unit cover to gain access to your hard drive, remember tor

remove any and all ESD (Electrical Static Discharge) from your body. This is done by

touching an object such as a doorknob or the case of the system unit. After this safety

precaution is done, remove the system unit cover and locate the drive.

Depending on the location of old your Hard Drive, you may have to remove other

components just to have access to it. If so, take very good notes of everything you

disconnect or remove, you can refer to them later as you replace the components.

Look to be sure you have empty drive bays to install extra drives should you decide to add
a second drive.
Once the drive is clear of other cables and components, carefully remove the power and
data cable from the drive and remove the drive retaining screws. Some drives are mounted
on rails, if this is the case,just slide the unit out through the front or top of the system unit
chassis.
Separate the drive from the rail and now install the new drive to the rail. Watch those
screws, they are small and can be easily lost. Remember to ground yourself from time to
time to remove electrical static buildup. Watch this short video to see the Drive being
installed in the system unit.
When the drive is mounted on the rail, (if you have one) write down any information on
the front of the drive that may give you the type, model number, sectors, cylinders, access
time and other information that seem important. You may need it when you configure the
hard drive. Nearly all new hard drives have software that does this for you.
After being certain that all cables,connections and all other components are in place,
replace the system unit cover, reconnect all peripherals to the system unit and plug it into
the wall outlet.
Turn on the computer. Now you will need to tell the computer that it has a new or different
hard drive. You will have to start your PC with a bootable floppy disk if you replaced or
installed a new hard drive.
If your new drive came with a owner's manual, keep it handy for future reference and you
may need it to config your drive. Even though you have installed the drive with its cable,
the computer doesn't know that you have done this. So we must tell the PC and while we
are at it, we must make the drive useable by partitioning and formatting it.